Full Specifications

General overview of refit, 2019-2020;

In 2019 the vessel was brought to the Boatyard to improve the systems and structure. This entailed the removal of much cabin top and sides to remove the old engine and install the new one. The fuel and water tanks as well as the plumbing was replaced to current standards. The electrical panels were removed and replaced with new as was the wiring of the vessel. Stripping the bottom to glass, repairing blisters, reglassing, epoxy barrier coating and fresh bottom paint. The teak decks, bulwark ceiling and cap rails were removed, repaired and laid back down. Much paint and bright work was finished after the carpenters were done with the cabin repairs and replacements. A detailed report was issued by the yard upon completion for serious parties.

Accommodations;

The pilothouse has port and starboard sliding doors, forward and below is the V-berth with enclosed head aft to starboard and cabinets aft to port. Aft is the galley with dinette to starboard and the sink, stove and cabinets aft to port.

Galley and Head;

3 burner propane stove

Bronze sink with cold pressure water

Head

Electrical;

3 batteries with parallel switch, 2020

120vac 30 amp shore power connection with cord, 2020

Solar panel, 2020

Solar charge controller, 2020

Battery charger

Rewiring done in 2020

Electronics and Navigation;

Garmin GPS map plotter, 2020

Raymarine I series autopilot with S100 remote, 2020

Uniden UM380 VHF radio, 2020

Hull and Deck;

Anchor chain and rode

Manual windlass

Teak decks, redone 2020

Perko brass spotlight

Brass navigation lights

Triple air horns with new compressor

Brass Dorades

Spruce mast and boom

Green cabin house with bright trim, 2020

Port and starboard pilothouse sliding teak doors

Brass cabin top hand rails

Aft companionway teak door to galley

Aft deck bimini with green canvas

Teak bulwark cap rails, 2020

Bronze hawse pipes

Mechanical Systems;

Fresh water cooling system

Bronze sea water strainers

New engine mounts, transmission, coupling and cutlass bearing, 2020

Dripless stuffing box, 2020

Reverse cycle HVAC

Hydraulic steering with teak wheel

Yanmar engine panel with tachometer, oil pressure and temperature gauges, 2019